Balloons and Blimps are lighter-than-air aircraft, which float in the sky. Inside the balloon compartment is a lighter-than-air gas such as helium or hydrogen. Due to the fact that hydrogen is lighter than air and the combinations of gases including oxygen in the atmosphere, the hydrogen wishes to rise and in doing so floats the balloon upward. By heating the gas inside the gas expands and fills up all the interior cavity of the balloon, simulating higher volumes.

I propose we stick smart dust inside balloons and blimps which will hold the heat temperature inside for longer and well as coating the inside of the balloon with heat reflective material which also absorbs and holds in the heat. These small smart dust particles will remain red hot for hours and as the atoms bounce off of them they will keep the gas inside warm. I propose that these smart dust particles have a certain temperature, which they will not exceed which would be about 5-8 degrees under the temperature from igniting the gas.

Additionally I propose that these particles remain on top of the balloon in a compartment which heats them and then releases them into the balloon as needed and as the fall and cool collects them at the bottom and vacuums them back to the top for heating to maintain buoyancy. I propose that this technique be used to maintain heavy loads over longer distances. Think on this.

"Lance Winslow" - Online Think Tank forum board. If you have innovative thoughts and unique perspectives, come think with Lance; www.WorldThinkTank.net/wttbbs/

• Reduce Flying Stress by Using Our HEADS


• Delta Cutting 9000 Jobs


• Older VTOL Designs Need a New Review


• Why Are All Aircraft Designs so Similar?


• Aircraft Carrier Air Funnel System


• Verbal Commands to Fly UAVs


• Delta Devastated and Delisted in Debt


• Anti Airborne Skimmer ICBM Threat Research Needed Now


• BMPs for Killing Hostile UAVs


• Why Do We Call UFOs; Unidentified Flying Objects?